User's Manual

Promi-MSP™

Installation Guide ver. 2.0

www.initium.co.kr

3. Configuration

If users finished configuring network settngs using serial console, now users need to select the

operation mode of Promi-MSP. Following three (3) ways can be used for selection of operation

mode:

1. Via Promi-MSP configuration software

2. Via Telnet (Control port)

3. Via Web brouser (Internet Explorer, etc.)

In this chapter, guide to use Promi-MSP configuration software will be introduced.

How to configure via Telnet or Web brouser will be introduced in Appendix.

3.1 Configuration via Promi-MSP software

3.1.1 When Promi-MSP is connected to PC directly

If users are going to connect Host PC and Promi-MSP directly using a crossed

cable, network settings as in the chapter 2.1 will not be required.

Promi-MSP has fatory settings: Static IP 192.168.1.10/24

For communication with Promi-MSP, set the IP of Host PC to have proper

address.

If you connected Promi-MSP to the Network, not to the Host PC, skip this chapter

and go to next chapter 3.1.2.

Open your Network Connections and see Property information of Local Network.

Change your IP address to Static:

IP: 192.168.1.11

Subnet: 255.255.255.0

Gateway: 192.168.1.1

These settings for direct communication only with Promi-MSP connected.