User's Manual

Promi-ESD User Manual – Appendix.E Regulatory Information E-5

As long as the 2 conditions above are met, no further evaluation under Article

3.2 of the R&TTE Directive and do not require further involvement of an R&TTE

Directive Notified Body for the final product. In all other cases, or if the

manufacturer of the final product is in doubt then the equipment integrating the

radio module must be assessed against Article 3.2 of the R&TTE Directive.

Please note that this product, Promi-ESD01, uses radio frequency bands not

harmonized throughout the Community. This product is classified as Class 2

radio equipment for which some Member States apply restrictions on placing on

the market and in use. Any parties putting Class 2 radio equipment on the market

must notify the relevant national spectrum management authority of their

intention, and the radio equipment must be given a Class Identifier (alert symbol).

 Antenna

This product, Promi-ESD, is for OEM integrations only. The end-user product

will be installed in such a manner that only the authorized antennas are used.

 Enclosure

This product, Promi-ESD, is made for integrating in another final product. For

this reason, there are some parts of the final product on which the Promi-ESD

depends for regulatory compliance regarding EMC and safety. The Promi-ESD is

mounted on the circuit board of the final product, and must be contained inside

the case of the final product. Integrated the Promi-ESD in the final product so

that its surfaces are not in contact with the outside.

 Documentation

In the documentation for the conformity assessment of the final product, state

clearly that the Promi-ESD is integrated in the system.