User Manual

16
PPPoE is a point-to-point protocol over Ethernet. User has to install a PPPoE Client on the basis of
original connection way. Through PPPoE, remote access devices could achieve the control and
charging of each accessed user.
WAN of the device is disabled by default.
Click the “Network>>WAN” menu in the navigation tree to enter the “WAN" Interface.
Table 3-2-2-1 Static IP Parameters of WAN
WAN - Static IP
Function description: Wired access to Internet via fixed IP.
Parameters
Description
Default
Shared connection
Enable—Local device connected to
Router can access to the Internet via
Router.
Disable—Local device connected to
Router cannot access to the Internet via
Router.
Enable
Default route
Enable default route
Enable
MAC Address
MAC Address of the device
00:18:05:08:07:3D
(provided by
InHand Networks),
provided for device
manufacturer
IP Address
Set IP address of WAN
192.168.1.29
Subnet mask
Set subnet mask of WAN
255. 255. 255.
0
Gateway
Set gateway of WAN
192. 168. 1. 1
MTU
Max. transmission unit, default/manual
settings
default (1500)
Multiple IP support (at most 8 additional IP addresses can be set)
IP Address
Set additional IP address of LAN
N/A
Subnet mask
Set subnet mask
N/A
Description
For recording significance of additional
IP address
N/A
Table 3-2-2-2 Dynamic Address (DHCP) Parameters of WAN
WAN - Dynamic Address (DHCP)
Function description: Support DHCP and can automatically get the address allocated by other
routers.
Parameters
Description
Default
Shared connection
Enable—Local device connected to
Router can access to the Internet via
Enable