User Manual

Manual Ver. 1
Integration Instructions
This instruction is to meet the requirement of FCC KDB 996369 D03 OEM Manual v01.
List of applicable FCC rules
As listed in the Statement section.
The specific operational use conditions
This module is approved by using three kinds of antenna arrangement which is listed in Layout Example
section. Other antenna arrangement is not covered by this certification.
Trace antenna designs
In the Layout Example section, item2 and 3, a PCB trace leads to the antenna is used. To use these two
kinds of antenna arrangement, please follow the layout example. Also follow the provided BOM,
schematic, and antenna specification for choosing the component. Below is the details for these trace
lead to the antenna.
Item 2. External Chip Antenna
Trace width: 16 mil
Trace impedance: 50 ohm
Trace isolation(distance to shielding ground): 6 mil
Trace thickness: 1 OZ
Item 3. External Inverted F PCB Antenna
Trace width: 18 mil
Trace impedance: 50 ohm
Trace isolation(distance to shielding ground): 6 mil
Trace thickness: 1 OZ
To verify the design by using this module, one can refer to the RF test report of this module to check if
any violation would happened. If happened, please inform us to help to check your design.
For production by using this module on the product, RF gain and emission has to be confirmed.
Any deviation from above design, require a Class II permissive change application.
RF exposure considerations
As listed in the Statement section.
Antennas
Two antennas are used for the certification, please check the specification for the details.
1. 2.4G Chip Antenna: RA00LPFA00MA000(MW2412)
2. 2.4G Inverted F PCB antenna
 INGICS TECHNOLOGY CO., LTD. • [e-mail] • WWW.INGICS.COM
13