Product Manual
04579629_ed4 EN-1
EN
Product Safety Information
Intended Use:
These Air Drills are designed for drilling, honing, reaming and hole sawing.
For additional information refer to Product Safety Information Manual Form 04580353.
Manuals can be downloaded from iredge.com.
Product Specications
Model
Chuck Size Free Speed Rated Power Tool Weight Overall Length
in mm rpm hp kW lbs Kg in mm
7811G 3/8 10 1700 0.5 0.38 2.7 1.22 7.4 188
EC112 1/2 13 500 0.5 0.38 3.67 1.67 7.9 200
Model
Average Air
Consumption
Air Consumption
@ Load
Sound Level dB(A)
(ISO15744)
Vibration (m/s²)
(ISO28927)
cfm l/min cfm l/min
† Pressure (L
p
) ‡ Power (L
w
)
7811G 4 113 29 825 87.1 98.1 <2.5
EC112 4 113 27 765 86.2 97.2 <2.5
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16606576 and table on page 2. Maintenance frequency is shown in a
circular arrow and dened as h=hours, d=days, and m=months of actual use. Items identied as:
1. Air lter 7. Coupling
2. Regulator 8. Safety Air Fuse
3. Lubricator 9. Oil
4. Emergency shut-o valve 10. Grease - during assembly
5. Hose diameter 11. Grease - through tting
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.