Product Manual

Page 10 of 12 66615X-X-C (en)
(Dimensions shown are for reference only, they are displayed in inches and millimeters (mm)).
11-1/2” (292 mm)
19-5/8”
(498 mm)
18-3/8”
(467 mm)
13-1/8” (333 mm)
10-3/4” (273 mm)
12” (305 mm)
2-3/4”
(70 mm)
9” (229 mm)
1/2” Slot (14 mm)
Material Outlet
Figure 6
7-5/8”
(194 mm)
Air Inlet
1/2-14 NPTF-1
Air Exhaust Thread
3/4-14 NPTF-1
14-13/16” (376 mm)
Material Inlet
1-1/2 - 11-1/2 NPTF - 1 (66615X, 66616X)
1-1/2 - 11 BSP (66617X, 66618X)
1-1/2 - 11-1/2 NPTF - 1 (66615X, 66616X)
1-1/2 - 11 BSP (66617X, 66618X)
DIMENSIONAL DATA - 6661X0, 1X2, 1XA and 1XC
Product discharged from exhaust outlet.
y Check for diaphragm rupture.
y Check tightness of (14) diaphragm screw.
Air bubbles in product discharge.
y Check connections of suction plumbing.
y Check “O” rings between intake manifold and uid caps.
y Check tightness of (14) diaphragm screw.
Low output volume, erratic ow, or no ow.
y Check air supply.
y Check for plugged outlet hose.
y Check for kinked (restrictive) outlet material hose.
y Check for kinked (restrictive) or collapsed inlet material
hose.
y Check for pump cavitation - suction pipe should be sized
at least as large as the inlet thread diameter of the pump
for proper ow if high viscosity uids are being pumped.
Suction hose must be a non-collapsing type, capable of
pulling a high vacuum.
y Check all joints on the inlet manifolds and suction con-
nections. These must be air tight.
y Inspect the pump for solid objects lodged in the dia-
phragm chamber or the seat area.
TROUBLE SHOOTING
RELEASED 13/Nov/2018 12:24:00 GMT