User's Manual

Access Point Product Specification Introduction
2 014-0030-00 Rev. G
does not have an internal cavity filter. It is EMC compliance certified to ETSI-301-489 and
ETSI-300-440.
5. ETSI RFID Configuration (Model: ULPAPE100)
The ETSI Radio Frequency Identification (RFID) configuration is limited to 10 dBm
conducted transmit power, up to 27 dBm EIRP, with three channels available (2446-
2454MHz). This configuration does not have an internal cavity filter. The hardware is the
same as the ETSI standard version; however the software is configured to accommodate
the power and frequency specifics. The AP is EMC compliance certified to ETSI-301-489,
ETSI-300-440, and EU REC 70-03 (Annex 11). APs are permitted to operate under EU REC
70-03 (Annex 11) in France, Germany, Ireland, Spain, Switzerland–Liechtenstein, and United
Kingdom.
6. Japan Configuration (Model: ULPAPE100)
The Japan configuration is limited to 10 dBm conducted transmit power and up to 12 dBm
EIRP with 41 channels available. It does not have an internal cavity filter. The hardware is
the same as the ETSI standard version, however the software is configured to
accommodate the power and frequency specifics. It is EMC compliance certified to
Japanese Radio Law; Item 19 of Article 12 (category WW) and ARIB STD-T66.
7. Hong Kong Configuration (Model: ULPAP110)
Hong Kong allows two different paths to certification utilizing rules for either China or
FCC/IC. The FCC/IC certification rules were used to certify the AP. Certification in Hong
Kong is based on the same information and tests provided for FCC/IC certification. The
Hong Kong version of the AP is identical to the FCC/IC version so all information is the
same. As with the FCC/IC configuration, the Hong Kong version supports transmit power
requirements up to 30 dBm conducted, 36 dBm EIRP, with 38 channels available. It contains
a cavity filter for high out-of-band rejection. It is EMC compliance certified to FCC Part 15C
Section 15.247 and IC RSS 210 Issue 7.
1.2 References
The following document provides additional details about the AP.
 AP Deployment Guide (PN: 010-0006-00 for 1.4 system and PN: 010-0021-00 for 2.1 system)
Provides network planning considerations, installation and software configuration guidelines
and instructions, and maintenance information for the AP as a part of the RPMA network which
enables remote wireless communication.