User's Manual

1 014-0030-00 Rev. G
1 Introduction
This document provides an overview of the Access Point and is shown below. It also provides
product specifications, characteristics, and requirements for the Access Point (AP).
Figure 1. Access Point
1.1 AP Product Configurations
The following AP product configurations are currently available for worldwide markets. The
Element Management System (EMS) software is used during network configuration and setup
of the AP. This software automatically configures the maximum allowed TX power levels (EIRP)
taking into account regulatory domain, antenna gain, and cable loss.
1. FCC/IC Configuration (Model: ULPAP110)
The Federal Communications Commission (FCC)/Industry Canada (IC) configuration
supports transmit power requirements up to 30 dBm conducted, 36 dBm EIRP, with 38
channels available. It contains a cavity filter for high out-of-band rejection. It is EMC
compliance certified to FCC Part 15C Section 15.247 and IC RSS 210 Issue 7.
2. FCC Sectorized AP (Model: ULPAP210)
The Sectorized AP Configuration is limited to 26 dBm conducted transmit power, up to 43
dBm EIRP, from (2402-2475.63MHz). This configuration requires two ULPAP110 APs
professionally installed, with each AP connected to a 17dBi 90 degree antennas.
3. FCC/IC Dual Latency Configuration (Model: ULPAP310)
The ETSI Dual Latency configuration is made up of two ULPE100, one for each sub-band,
connected to the antenna through a diplexer. The software configures each sub-band
channel to a maximum of 30dBm at the antenna port. The antenna gain must be such that
the maximum radiated power is 36dBm EIRPper channel. The system processess two
independent information streams through the diplexer to the antenna. Each diplexer sub-
band allows 3 or 4 one MHz channels. There are four possible sub-bands. The system is
professionally installed.
4. ETSI Standard Configuration (Model: ULPAPE100)
The European Telecommunications Standards Institute (ETSI) configuration is limited to
10 dBm of conducted transmit power, up to 10 dBm EIRP, with 40 channels available. It