User's Manual

Access Point Product Specification Hardware Requirements
17 014-0030-00 Rev. G
Manufacturer
Part Number
Gain
Comment
GPS Antenna
PCTEL
GPSL1-TMG-SPI-40NCB
40 dBic
N-type connector,
active gain, lightning
protection
Table 16. Antennas for Japan Configuration
Manufacturer
Part Number
Gain
Comment
Main Antenna
L-Com
HGV-2404U
4 dBi
Limited to 8 dBm
conducted TX
GPS Antenna
PCTEL
GPSL1-TMG-SPI-40NCB
40 dBic
N-type connector, active
gain, lightning
protection
7.2 RF Cable Requirements
It is generally recommended to use very low loss cable such as LMR400. The acceptable loss
ranges are listed in Table 2. Summary of AP Product Specifications. The length that can be
achieved within these ranges depends on the cable chosen.
7.3 Ethernet Speed and Cable Requirements
Unshielded CAT5 (or CAT5E or CAT6) with a length up to 100 meters is permissible. For ETSI
markets the host Ethernet adaptor must be configured for 10 MB full duplex communication,
not 100 MB or auto. Using 100 MB speeds will result in non-compliance to ETSI EMC
regulations, per 489-2: clause 8.7.
7.4 LEDs
The AP has two green LEDs that are visible on its front panel.
 Status
This LED indicates RPMA network receive/transmit activity. The AP must be online and
active.
 Link
This LED reflects the status of Ethernet activity for the AP.