User's Manual

Access Point Product Specification Product Specification Overview
5 014-0030-00 Rev. G
Requirement Description
Requirement
Comments
Link
Current Consumption
0.35A maximum
@ 48 VDC
See section 3.3 for details.
3.3
GPS Power
3.3 VDC @ 50 mA maximum
over coaxial cable
DC power supplied on GPS RF
connector.
5
Transmitter Related
Transmit Power Range
0 – 16 dBm (LP)
16 – 30 dBm (HP)
Referenced to AP N-connector.
Switchover point (16 dBm) is
approximate.
Transmitter Rated Power by
market (Country: Agency):
 United States: FCC
 Canada: IC
 Europe: ETSI
 Europe: ETSI (RFID)
 Japan: TELEC
 Hong Kong: OFTA
 South Africa: ICASA
 Brazil: ANATEL
 Korea: RRA
 Singapore: IDA
 Macau: DSRT
Maximum TX EIRP:
 36 dBm
 36 dBm
 10 dBm
 27 dBm
 12 dBm
 36 dBm
 10 dBm
 26 dBm
 10 dBm
 20 dBm
 20 dBm
Modulated conditions.
ETSI is the default choice for all of
Europe.
ETSI RFID is only allowed in
certain countries of the EU***.
Requires quad-sector antenna
(not Omni).
Peak to Average Ratio
 2.9 dB
Signal Bandwidth
 1 MHz
BT Factor
0.46
TX Spectral Bandwidth
2.32 MHz
99% bandwidth (-20 dB each side)
6.1
ACPR
≤ -30 dBc
Spec and test method comes from
FCC 15.247(d).
Harmonics
≤ -47 dBm
At any TX power level. Note
harmonics fall into FCC restricted
bands.
Transmit Power Level
Accuracy
≤ 1.7 dB
Estimated sum of all contributors.
Normal link mode (closed loop).
Transmitter Spurious Outputs
In-band but >1 MHz offset
30 MHz to 2400 MHz
2480 MHz to 8000 MHz
< -45 dBm
< -70 dBm
< -70 dBm
At any TX power level. Applies to
spurious, not ACPR or harmonics.
Load VSWR Range
 1.4:1
( ≤ -15dB RL)
Exceeding this range influences
power accuracy.
6.2
Customer RF Cables Loss
Range
FCC: 0 dB to 3 dB
Others: 0 dB to 5 dB
GPS: 0 dB to 5 dB
Range of acceptable cable losses
connecting the AP to its
respective antenna.
7.2
Customer Ethernet Cable
Length
≤ 100 meters
Maximum length for emissions
compliance.
7.3