User's Manual

Access Point Product Specification AP Software Configuration via Web Interface
26 010-0021-00 Rev. G
7. Log into the AP as described in section 7.2.
8. After successfully logging into the AP, select “Admin” in the upper right corner of the
screen.
9. From the Admin menu, select the Network submenu.
10. Follow the instructions in section 7.6.2 to make the required changes to the IP address,
Netmask, and Default Router.
11. When you have completed the changes, be sure to click on the Save button and then click
on the Reboot Access Point button.
12. After these changes are made and the customer’s firewall and routers have been properly
configured, the AP can be remotely configured.
For additional support with AP configuration, contact the Ingenu’s’ Network Operations Center
(NOC) Team at [e-mail].
7.2 Login
The AP has a factory default IP Address of 192.168.1.1 which allows connection to the AP
configuration page using https protocol on port 443.
13. To access the AP configuration page, ensure the following:
 You are on the same subnet with the AP or your router can route to the AP IP address. The AP’s
default router setting is 192.168.1.254.
 You have access to port 443 on the firewall
14. Open your web browser.
15. In the address bar of the browser, type https://192.168.1.1. A dialog box opens that looks
similar to the following:
Figure 16. Username and Password Prompt
16. Enter the default User Name and Password.
User Name: admin
Password: onramp
17. Click on the Log In button.