Specifications
Table Of Contents
- Revision History
- 1 Overview
- 2 DC and RF Characteristics
- 3 Electrical Interface
- 4 Safety Considerations
- 5 Regulatory Considerations
- 6 Installation of TRN-2013 Board
- 7 Provisioning
- Appendix A RF Test Mode Interface
- A.1 Normal Operating Mode 0
- A.2 Non-Persistent Idle / Factory Test Mode 1
- A.3 Persistent Idle / Factory Test Mode 2
- A.4 Non-Persistent Node RF Test Mode 3
- A.5 Persistent Node RF Test Mode 4
- A.6 Non-Persistent Manufacturing Cal Mode 5
- A.7 Persistent Manufacturing Cal Mode 6
- A.8 Non-Persistent Meter Diagnostic Mode (Not Yet Implemented)
- A.9 Setting eMCM to Test Mode 1 - Non-Persistent Idle Factory Test Mode
- A.10 Setting eMCM to Test Mode 2 - Persistent Idle Factory Test Mode
- A.11 Setting eMCM to Test Mode 3 - Non-Persistent RF Test Mode
- A.12 Setting eMCM to Test Mode 4 - Persistent RF Test Mode
- Appendix B REACH Compliance Statements
- Appendix C Abbreviations and Terms
- Appendix D TRN-2013 Mechanical Drawing and Schematics
TRN-2013 Integration Specification Regulatory Considerations
On-Ramp Wireless Confidential and Proprietary 16 014-0057-00 Rev. B
WARNING: This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, this equipment may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
5.5 IC Warnings
The installer of this radio equipment must ensure that the antenna is located or pointed so that
it does not emit RF field in excess of Health Canada limits for the general population. Consult
Safety Code 6 which is obtainable from Health Canada’s website
http://www.hc-sc.gc.ca/index-
eng.php.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
To reduce potential radio interference to other users, select the antenna type and its gain so
that the equivalent isotropically radiated power (EIRP) is not more than that permitted for
successful communication.
Canadian Two Part Warning Statement:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
5.6 Usage
FCC ID: XTE-TRN-2013. IC: 8655A-TRN-2013. This device is only authorized for use in fixed and
mobile applications. To meet FCC and other national radio frequency (RF) exposure