User's Guide

ManualsBrandsINGENICO ManualsPOS EquipmentPayment terminal

Table Of Contents

Desk Series

900024281 R11 001 02/2022

This device complies with Part 15 of the FCC Rules and Industry

Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions:

(1)

This device may not cause harmful interference, and

(2)

This device must accept any interference received,

including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada

applicables aux appareils radio exempts de licence. L’exploitation

est autorisée aux deux conditions suivantes

(1)

l’appareil ne doit pas produire de brouillage, et

(2)

l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible

d’en compromettre le fonctionnement.

Under Industry Canada regulations, this radio transmitter may

only operate using an antenna of a type and maximum (or lesser)

gain approved for the transmitter by Industry Canada. To reduce

potential radio interference to other users, the antenna type and

its gain should be so chosen that the equivalent isotropically

radiated power (e.i.r.p.) is not more than that necessary for

successful communication.

Conformément à la réglementation d’Industrie Canada, le présent

émetteur radio peut fonctionner avec une antenne d’un type et

d’un gain maximal (ou inférieur) approuvé pour l’émetteur par

Industrie Canada. Dans le but de réduire les risques de brouillage

radioélectrique à l’intention des autres utilisateurs, il faut

choisir le type d’antenne et son gain de sorte que la puissance

isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité

nécessaire à l’établissement d’une communication satisfaisante.

This device complies with FCC and ISED radiation exposure

limits set forth for general population (uncontrolled exposure)

in accordance with FCC rule part §2.1093, KDB447498 D01 and

RSS-102 Issue 5 for portable use conditions.

This device has been tested according to the RF exposure

guidelines for typical hand-held operation in direct contact (0

cm distance) to the user’s hands and must not be collocated or

operating in conjunction with any other antenna or transmitter.

Cases with metal parts may change the RF performance of the

device, including its compliance with RF exposure guidelines, in a

manner that has not been tested or certified.

Use of this device with an accessory in order to be worn and

operated on user’s body is strictly prohibited and will invalidate

the certifications obtained for FCC and ISED.