Specifications

To connect your CheckManager 3000 to a telephone line:
1. Insert one end of the supplied telephone line cable into one of the modular telephone
connectors on the back of the CheckManager 3000.
2. Insert the free end of the telephone line cable into the modular telephone jack.
3. If a telephone set or other equipment is currently connected to the telephone wall jack, unplug
it. If you wish to use the telephone set or other equipment, plug the connector into the free
modular telephone jack in the CheckManager 3000, as described below in connecting a POS
terminal or telephone set.
Connecting Peripheral Devices
The built-in ports on the CheckManager 3000 allow you to attach up to three optional devices:
• Serial printer to the 8-pin DIN connector.
• POS terminal or standard telephone set to the RJ11 connector.
• Optional 3-track magnetic stripe reader to the 10-pin modular jack connector.
Connecting a Printer
Each printer uses a special type of cable, which is ordered separately.
To connect a printer/PC to your CheckManager 3000:
1. Ensure that the CheckManager 3000 is not powered-up
2. Insert the male 8-pin DIN end of the printer cable into the 8-pin port on the back of the
CheckManager 3000.
3. Insert the other end of the printer cable into the appropriate serial port on your printer. For
further instructions, refer to the installation instructions included with your printer.
Connecting a POS terminal or telephone set.
The second modular telephone jack in the CheckManager 3000 can be used to connect a POS
terminal or telephone set. This allows you to make a normal voice or credit card authorization calls
when the CheckManager 3000 is not in use processing a check authorization transaction.
To connect a POS terminal / telephone set the CheckManager 3000:
1. Ensure that the power is unplugged from the CheckManager 3000.
2. Insert one end of the telephone line into the free modular jack on the back of the
CheckManager 3000.
3. If not already connected, insert the other end of the telephone line into the appropriate jack on
your POS terminal or telephone.
Connecting Power
The CheckManager 3000 does not have a power switch. As soon as you connect the unit to power, it
is powered up.
1. Insert the small plug on the power transformer into the CheckManager 3000 receptacle.
2. Plug the power transformer into a 120-volt AC power outlet.
NOTE: The CheckManager 3000 should be supplied with a UL listed power transformer unit marked
Class 2. The power output of the transformer is 10VAC, + / - 5%, 1500mA with maximum open load
voltage of 12.5VAC.
Rev. 04/19/2006