Flexfence Pro Man.
Flexfence Pro Man.
Flexfence Pro Man.
Ingal Civil Products Flexfence 4.3 END TERMINALS End terminals are designed to provide a soft gating impact to prevent vehicles from launching or snagging upon impact with Flexfence WRSB. 4.3.1 TL3 Flexfence Terminal The TL3 Flexfence Terminal has been crash tested to meet the requirements of NCHRP 350 Test Level 3 (TL3). The Flexfence TL3 Terminal is the only TL3 terminal proven NOT to release the cables during approach impacts.
Flexfence Ingal Civil Products 5.4 Installation of Anchor Blocks 5.5 Construction of Post Footings 1. Excavate the anchor hole in accordance with Ingal drawings ensuring the centre of the anchor block is in line with the centre line of the wire rope fence. 1. Establish post spacing in accordance with expected dynamic deflections and excavate postholes. Typically the footings are 300mm diameter x 600mm deep using 32Mpa concrete. 2.
Ingal Civil Products Flexfence 5. When all ropes have been installed, fit the rope hook through the pre-punched holes in the posts. 6. Fit the plastic caps to the posts. The rope hook will provide extra resistance to vehicle updraft and wind. 0,!34)# 0/34 #!0 34!).,%33 &2!-% 7) 7 2% 2/ 2 )2% 7) 2% 2/ For fences less than 600m; 1. Attach safety check ropes to the wire ropes at the leading or high-end anchor. Swage end fittings onto all cables and attach to the anchor bracket.
Ingal Civil Products Flexfence For fences greater than 600m 1. Attach safety check ropes and machine swage cables at leading or high-end anchor and attach to anchor bracket. 6. At other anchor, pretension cables, clamp off to a post, attach safety check ropes and machine swage fittings. 2. At 1st tension bay, install the hydraulic tensioning unit between a clamp on the 1st cable and the bottom of a post located 5m away. Pretension the cable to 800kg and clamp off to a post. 7.
Flexfence Ingal Civil Products 5.9 Installation Checklist To ensure the correct installation of Flexfence WRSB, you must have answered yes for each question.
Ingal Civil Products Flexfence 6.0 FLEXFENCE WRSB MAINTENANCE Flexfence WRSB is a very low maintenance roadside safety barrier. Except for repairs due to impacts, there is virtually no maintenance required for the system. It is recommended that regular drive-by inspections be performed to ensure the following; 1. Post caps have not dislodged. Delineation stickers are attached to the post caps as a loss of numerous caps could result in poor delineation. 2. Debris has not accumulated around the system.
Ingal Civil Products Flexfence APPENDIX A: RECOMMENDED DYNAMIC DEFLECTION DESIGN MULTIPLYING FACTORS FOR WIRE ROPE BARRIERS Table 3: Curve and length factors for cable barriers Degree of Curvature (Degrees) Barrier Length (metres) 0.0o 30 0.85 0.88 0.89 0.91 0.91 0.93 0.95 0.97 0.99 60 0.96 0.98 1.01 1.05 1.08 1.12 1.17 1.21 1.26 90 1.00 1.06 1.11 1.14 1.17 1.23 1.28 1.33 1.39 120 1.08 1.11 1.17 1.21 1.29 1.32 1.35 1.48 1.55 150 1.11 1.16 1.20 1.25 1.34 1.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Release 002 Flexfence Pro Man.
Ingal Civil Products A Division of Industrial Galvanizers Corporation Pty.Ltd. for moreinformation NEW SOUTH WALES Sydney (Head Office) 57-65 Airds Road, Minto, NSW 2566 Ph: +61 2 9827 3333 Fax: +61 2 9827 3300 QUEENSLAND Brisbane 90 Mica Street Carole Park QLD 4300 Ph: (07) 3271 3369 Fax: (07) 3271 3299 VICTORIA Melbourne 28-38 Albert Street Preston VIC 3072 Ph: (03) 8470 0082 Fax: (03) 9480 1834 WESTERN AUSTRALIA Perth 9 Millrose Drive Malaga WA 6090 Ph: (08) 9249 3155 Fax: (08) 9249 3166 www.
