Reference Manual

Frequently Asked Questions
Universal Control Panel
What type of dimmers can I use with the Universal Control Panel?
The Universal Control Panel can use any 0-120VAC dimmer, including smart dimmers to integrate with your app
and Bluetooth capable devices.
Do I need to feed the 0-120VAC dimmer with power?
Yes. Provide power to the dimmer to signal the switch leg to go to the control signal terminal strip in the Universal
Panel. Generally power is pulled from a circuit close to the dimmer.
Slimline
Can I recess a SL-Series heater?
No. The SL-Series heater housing operates at a significantly higher temperature than the W-Series or C-Series
fixtures due to the narrow profile and tight clearances to the heating element. The SL housing would exceed safe
operating temperatures for wiring with restricted air circulation.
Can the SL-Series heater be painted or powder coated?
No. The SL-Series heater housing is anodized aluminum. It is available in a silver, stainless colored finish or an
almost black anodized finish. Paint or powder coating interferes with the T-slot, and reduces heat dissipation. This
layer of paint "insulation" increases the operating temperature of the housing beyond acceptable limits.
Why has my Slimline reflector distorted or warped?
There are two possible reasons. First and most common would be because the safety grill is not properly installed
in the channel, between the reflector returns, and under the stainless trim ring. The grill needs to be in the
channel to hold the reflector properly placed.
The reflector is designed to expand and contract as the housing heats and cools at a different rate. The reflector
has slotted holes on each end. If the screws securing the end are over tightened (tight to the bottom) the reflector
can deform with the grill in place. During assembly the end screws are backed out, from ½ to 1 full turn to allow
room for expansion. This is important to know should you need to replace a reflector for damage or maintenance.
Will the SL-Series heater generate the same heat as a comparably rated
W-Series heater?
Yes, they will have the same heat output. A watt = watt. The difference is in the styling, and construction, but with
the narrower design of the SL units, the heat pattern is slightly more concentrated towards the center.
Do I need to use the supplied mounting brackets?
No. The installer can use any desired bracket that meets the minimum clearance requirements. You can use a ¼"
hex bolt head in the T-slot if attaching to structural tubing.
3
Frequently Asked Questions