IO 213-LP Submittal

IO-210 SUBMITTAL
SD110614
RL: 4C
RD: DEC 2017
2
DIMENSIONS IO-210 SE-
Front View
10”
13”
IO-212 = 30 1/2”
IO-213, IO-252 = 43
QTY
MODEL
NO.
INPUT
CAPAC-
ITY BTUH
GAS
1/2” GAS INLET PIPE SIZE
MANIFOLD
PRESSURE
ELECTRI-
CAL
WEIGHT
(LBS.)
MINIMUM GAS
LINE PRESSURE
MAXIMUM GAS
LINE PRES-
SURE
IO-212-N 23,000 NAT 6” W.C. 14” W.C. 5” W.C.
VOLT-
AGE
24VAC
CUR-
RENT
AMPS
40VA*
32
IO-212-L 23,000 LP 11” W.C. 14” W.C. 10” W.C. 32
IO-213-N 35,000 NAT 6” W.C. 14” W.C. 5” W.C. 44
IO-213-L 35,000 LP 11” W.C. 14” W.C. 10” W.C. 44
IO-252-N
50,000/
35,000
NAT
ONLY
6” W.C. 14” W.C. 5” W.C. 49
*For a multiple heater installation, the transformer is sized: 40 VA for the first heater + 20 VA for each
additional heater. If total VA is between transformer sizes, select the next higher VA rating.
CERTIFICATION
The IO-210 Series heater is approved for outdoor and indoor use to the following standards:
 Outdoor: ANSI Z83.26 / CSA 2.37 Gas-Fired Outdoor Infrared Patio Heaters
 Indoor: ANSI Z83.19 / CSA 2.35 Gas-Fired High Intensity Infrared Heaters
Outdoor Definition per ANSI Z83.26 / CSA 2.37 Approval Standard.
An appliance approved for “outdoor use” may be installed with shelter no more inclusive than:
 With walls on all sides, but with no overhead cover, (overhead permanently open) or

Within a partial enclosure which includes an overhead cover and no more than two side
walls. These side walls may be parallel, as in a breezeway, or at right angle to each
other. The open sides must be permanently open or

Within a partial enclosure which includes an overhead cover and three side walls, as
long as 30 percent or more of the horizontal periphery of the enclosure is permanently
open.
If “outdoor” conditions are not met, Models IO-212 & IO-213 are approved for “indoor
use” and ventilation requirements of local codes apply.
All Models
End View
Front View