User Guide

When you hear the “beep”, the startup display should
disappear, and you should see something like this:
3) In this display, in the upper left, “HOLD” means “Data
Hold”. When the trigger is released, the meter holds the
real-time temperature display in the largest digits.
The smaller digits below are the
Maximum/Minimum/Average/Different/High Alarm/Low
Alarm temperature if you’re in those modes.
4) “∈=0.95” means that the meter is set for an average type
of object which “emits” radiant energy in an average way.
If you know the “emissivity” of the object you wish to
measure is different than 0.95 you can adjust this figure,
see below in the full instructions.