User Guide

Quick Start Guide

1) Use that included phillips screwdriver to unscrew the small

screw at the bottom of the handle. Open the battery

compartment. Remove any plastic from the battery.

Connect the battery to the connector. Reinstall battery into

the compartment. Close compartment. Screw the screw

back in.

2) Squeeze the trigger while aiming at some non-human

object. (DON’T look into the end of where the lase

r comes out. It can harm your eyes.)

You should see this on the display:

PAGE 1
Quick Start Guide 1) Use that included phillips screwdriver to unscrew the small screw at the bottom of the handle. Open the battery compartment. Remove any plastic from the battery. Connect the battery to the connector. Reinstall battery into the compartment. Close compartment. Screw the screw back in. 2) Squeeze the trigger while aiming at some non-human object. (DON’T look into the end of where the lase r comes out. It can harm your eyes.
PAGE 2
When you hear the “beep”, the startup display should disappear, and you should see something like this: 3) In this display, in the upper left, “HOLD” means “Data Hold”. When the trigger is released, the meter holds the real-time temperature display in the largest digits. The smaller digits below are the Maximum/Minimum/Average/Different/High Alarm/Low Alarm temperature if you’re in those modes. 4) “∈=0.
PAGE 3
The “ ” says the lasers are visible if you can see the on the display. If you press the “ ” button when the meter is on you can toggle back and forth between the laser being visible and not visible. In the upper right corner of the display it will either show the ℉ for Fahrenheit readings or ℃ for Centigrade readings. You can toggle back and forth by pressing the T/DN button in the lower right corner of the keyboard.