User's Manual

6
Below is the diagram of the lower front
of the machine
E Key Switch
F Emergency Button
Steps to turn the RPM on are listed below:
1. Plug the power cable into the machine (A)
and then to the power outlet.
NOTE: Uninterrupted power supply (UPS)
battery is strongly recommended
2. Plug the Ethernet cable into the machine
(C) and then to the hospital network source.
3. Double check to make sure the circuit
breaker (B) is up and emergency button (F)
is out.
NOTE: If the circuit breaker is down, pull
both levers up until they click
NOTE: If the emergency button is pushed
in, twist the switch clockwise to pull it
out
4. Turn the key (E) to turn on the machine
E
F
ON
OFF