User's Manual

11
Key Parts of Print Assembly
A Driving Shaft
B Following shaft
C Print Head Assembly
D Ribbon sensor
E Ribbon Rollers
F Rubber Roller
Installing Print Ribbon
1. Trash the used roll on the driving shaft
(A) but save the empty cardboard on the
following shaft (B)
2. Install the saved cardboard to the driving
shaft
3. Install a new print ribbon. Feed the
ribbon over two ribbon rollers and print
head assembly (C). Use the adhesive at
the very beginning of the ribbon to
connect it to the empty cardboard on the
driving shaft
NOTE: Make sure that the ribbon goes
through the ribbon sensor
4. Turn the driving shaft to pull the ribbon
until the clear part of the ribbon is rolled
up and sensor senses the ribbon. The
ribbon sensor will turn off the green LED
light
A
B
C
D
F
E