User's Manual

10
Installing Paper
Steps to turn the RPM on are listed below
1. Pull the lower unit out by using the pull-
out handle (B)
NOTE: Do not use the conveyor (C) to pull
the unit out
2. Remove the empty barrel from the paper
mount (E)
NOTE: Make sure the barrel does not
leave its magnets on the paper mount.
3. Lock the lower unit by using lower unit
lock for easier operation (G)
4. Feed the old paper through the v sealer
(H)
5. Insert the new roll to the paper mount
then feed the paper around the paper
guide rollers (F) and through the v sealer
6. Close and hold the v sealer for 5 seconds
to attach the two pieces together. While
holding, remove the excess by pulling
towards the right.
7. Once attached, press forward button on
the control box (A) until the connected
parts are out of the machine