User's Manual

• 18 • • 19 •
Setting Your Meter
Battery Use
The LipidPro
TM
requires two(2) AAA 1.5 volt alkaline batteries.
When to replace the batteries:
The meter will give you an indication on the display that the batteries need to be
changed. When the display reads battery sign, no more tests can be run until the
batteries are changed. Always replace the batteries with high quality alkaline
batteries. It is recommended to keep a spare set of batteries on hand. To extend
battery life, remove the Test Strip as soon as a result is displayed.
How to install /replace the batteries:
1. Open the battery door on the back of the LipidPro
TM
.
2. Remove old batteries from the compartment and safely discard.
3. Insert the new batteries into the battery compartment as marked on the inside
compartment.
4. Replace the battery door. To make sure the batteries were installed correctly,
push either one of the two buttons on the front of the meter to turn the
LipidPro
TM
on.
Setting Your Meter
Setting Mode
It is recommended to set your LipidPro
TM
meter properly before using.
The meter enters setting mode with a beep sound
by pressing the mode ( ) button for 3 or more
seconds in the stand-by status.
Press mode ( ) button for the next step.
Caution
Remove both batteries from the battery compartment and dispose of them
according to your institution's guidelines.
Caution
Make sure that the date and time are set properly to enable your data to be
stored and downloaded properly.
By pressing ▲▼ , adjust year and press MODE
( ) button.
By pressing ▲▼, adjust date, month and time, and
then press MODE ( ) button.