User's Manual

INFOPIA CO., LTD Page 7 UM-M (Rev.0)
Components
Using the Clear Tip(AST)
1. Place the lancing device and lancet on the skin in the
chosen area, press and hold it continuously for a few
seconds, then push the release button to take a blood
sample.
2. Watch through the clear tip until a sufficient blood sample
is taken. If there is not enough blood, gently massage the
area until a sufficient sample is collected.
STORAGE
Products must be stored at room temperature protected
from sunlight or moisture.
CLEANING AND DISINFECTION
-Clean and wipe the outer part of lancing device once a
week at the minimum with a soft cloth dampened with mild
soap and water. Wash the adjustable tip and clear tip, once
a week with mild soap.
-DO NOT immerse the lancing device in water or liquid.
WARRANTY
Lancing device has a 2-year warranty from the date of
purchase.
A malfunctioning device should be returned to the following
address:
Manufacturer :
GMMC
Room No. 1112, Ace Tower 9th Bldg., 345-30, Gasan-
dong, Geumcheon-gu, Seoul, South Korea
Tel : [phone]
Fax : [phone]
EU Authorized Representative :
GMMC, S.L.
C/Vinalopo' 4 - 1° - Pta 4 Valencia, Spain
Tel : [phone]
Fax: [phone]
Performing a blood test with your fingertip
Step 1
1. Firmly insert the test strip into the
meter test port. Insert down firmly in
direction of arrow on test strip (arrow up).
Please do not insert the glucose test strip
upside down.
When you insert the glucose test strip
into the glucose test meter, the power
automatically turns on with the code and
temperature.
2. Make sure the code number matches
on the strip bottle its code (e.g. C26).
The IGM-1001D automatically
recognizes the test strip code number
and adjusts the meter accordingly.
A blinking test strip will appear at the top
of the screen indication the meter is
ready for testing
CAUTION
1. If the code is not displayed after for a while, pull the
glucose test strip out of the port, and re-start the
procedure from the beginning.
2. If the code on the LCD display window as well as on the
glucose test strip vial does not match, try another new
glucose test strip. If the mismatch persists, please
contact your local representative for assistance.
3. Avoid testing under direct sunlight, for a more accurate
test result.
4. If you apply your blood sample too early, Er5 message
will appear on LCD. Please refer to Page 12.
Step 2
To obtain a suitable blood samples
 Before obtains a blood sample, wash your hands with
warm, clean water and soap. Dry hands completely
before testing.
WARNING
1. All parts of the kit are considered bio hazardous and can
potentially transmit infectious disease, even after you
have conducted cleaning and disinfection measures.
2. To reduce the chances of getting infection: The test
strips are for single use only. Do not reuse.
3. Avoid getting hands lotion, oil, dirt or debris in or on the
lancets (single use only) and the lancing device.
4. Wash your hands thoroughly with soap and clean water
after handling the meter, lancing device and/or test strip.