Operation Manual

31
Item Description
Time difference
Congures the time difference. Set the same time difference
to match your computer. If unsure, consult your IT manager.
SNTP
Click the [ON] check box to retrieve Date and Time
information from the SNTP server and set the following items.
SNTP Server Address
Congures the SNTP server address in IP format.
• The address allows an IP address or domain name if a valid
DNS server is congured in
Network Settings
. The host or
domain name can be up to 255 characters.
Cycle
Congures the interval when Date and Time information from
the SNTP server should be retrieved (
hour:minute
).
Click the [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
network connection. When the conguration settings change, you must restart
the network connection. You can restart the network connection from Network
Restart on the main menu(&41).
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• Once you turn off AC power or the projector goes into SAVING mode
(&SETUP menu in the Operating Guide), the current date and time setting is
reset.
• To enable the SNTP function, the time difference must be set.
• When SNTP is enabled, the projector will retrieve Date and Time information
from the time server and override other time settings.
• The internal clock’s time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
NOTE
3.1 Projector Web Control - Date/Time Settings (continued)
3. Web Control