Operation Manual

25
3.1.6 Alert Settings
Displays and congures failure & alert settings.
Item Description
Cover Error
The lamp cover is not installed correctly.
Fan Error
The cooling fan is not operating.
Lamp Error
The lamp does not light, and the projector's interior may be
overheated.
Temp Error
The projector's interior may be overheated.
Air Flow Error
The internal temperature is rising.
Cold Error
The projector's interior may be too cold.
Filter Error
The lter must be replaced.
Other Error
Other error.
If this error is displayed, contact your dealer.
Schedule Execution
Error
Schedule Execution error. (
&27
)
Lamp Time Alarm
The lamp time has expired.
Filter Time Alarm
The lter time has expired.
Filter Status Notication
The details of the air lter status will be displayed.
Transition Detector
Alarm
The projector has been moved. (
&
SECURITY menu
in the
Operating Guide
)
Cold Start
When the projector is supplied with power, it works as below.
• If STANDBY MODE is set to NORMAL: the projector's power
status changes from “OFF” to “Standby state”.
• If STANDBY MODE is set to SAVING: the projector's power status
changes from “Standby state” to “ON (lamp is turned on)”.
(
&
SETUP menu
in the
Operating Guide
)
Authentication Failure
The SNMP access has been denied.
Refer to
&
Troubleshooting in the Operating Guide for further details on the
errors listed above except for Other Error and Schedule Execution Error.
3. Web Control
3.1 Projector Web Control (continued)