Operation Manual
13
1. Connection to the network
1.4 Manual network connection setting - Wireless LAN - (continued)
4) Select "Use the following IP address" and congure the IP
address, Subnet mask and Default gateway for the computer
accordingly.
After completing the settings, click [OK] to close the window.
(continued on next page)
[About the IP address]
The Network address portion of the IP address setting on your computer and your
projector must match. In addition, the computer's IP address must be unique from
any other device, including the projector, in the network.
The projector’s settings are as follows:
IP address: 192.168.10.254
Subnet mask: 255.255.255.0
(Network address: 192.168.10 in this case)
Therefore, specify the computer’s IP address as follows:
IP address: 192.168.10.xxx (xxx shows decimal number.)
Subnet mask: 255.255.255.0
(Network address: 192.168.10 in this case)
For example
Select a number from 1 to 254 for “xxx” which is unique from other equipment.
In this case, since the IP address of the projector is “192.168.10.254”, specify
a setting between 1 to 253 for the computer.
• “0.0.0.0” cannot be set to the IP address.
• The projector’s IP address can be changed by using the conguration utility
from a web browser. (&20)
• If the projector and the computer exist in the same network (i.e., same
network address), you can leave the default gateway eld blank.
• When the projector and the computer exist in different networks, the default
gateway must be set.
NOTE