Operation Manual

13
When the projector is connected to the network, the projector can be controlled
with RS-232 commands from the computer's web browser.
For RS-232 command details, refer to the RS-232 Communication / Network
command table (&17).
Command Control via the Network
LAN
USB wireless adapter
LAN cable (CAT-5 or greater)
Connection
1.
Turn off the projector and the computer.
2.
If you are using a wired LAN, connect the projector's LAN port to the
computer's LAN port with a LAN cable. Use the cable that fullls the
specication shown below. If you are using a wireless LAN, insert the USB
wireless adapter into one of the USB TYPE A ports of the projector.
3.
Turn the computer on, and after the computer has started up, turn the
projector on.
NOTE • If data is transferred via wireless and wired LAN at the same
time, the projector may not be able to process the data correctly.
Command Control via the Network