Projector User's Manual
Table Of Contents
- Table of contents
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Using the menus
- Securing the projector
- Switching input signal
- Creating your own startup screen
- Adjusting the projected image
- Magnifying and searching for details on the projected picture
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Locking control keys
- Freezing the image
- Hiding the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
Maintenance54
4. Loosen the screw that secures the lamp.
5. Lift the handle so that it stands up. Use the
handle to slowly pull the lamp out of the
projector.
CAUTION
• Pulling it too quickly may cause the lamp to break
and scatter broken glass in the projector.
• Do not place the lamp in locations where water
might splash on it, children can reach it, or near
flammable materials.
• Do not insert your hands into the projector after
the lamp is removed. If you touch the optical
components inside, it could cause color
unevenness and distortion of the projected
images.
6. As shown in the figure, lower the new
lamp first into the connector on the
projector and align the two holes on the
projector.