Projector User's Manual
Table Of Contents
- Table of contents
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Using the menus
- Securing the projector
- Switching input signal
- Creating your own startup screen
- Adjusting the projected image
- Magnifying and searching for details on the projected picture
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Locking control keys
- Freezing the image
- Hiding the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
Operation30
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at
either the top or bottom. It occurs when the projector is not perpendicular to the
screen.
To correct this, besides adjusting the height of the projector, you will need to
manually correct it following ONE of these steps.
• Press / on the projector or remote
control to display the Keystone correction
page. Press to correct keystoning at the
top of the image. Press to correct
keystoning at the bottom of the image.
• Press Menu/Exit on the projector or remote
control. Go to the
DISPLAY > Keystone and
adjust the values by pressing or on
the projector or remote control.
Keystone
BackMENU
Press /.
Press /.