User Manual

Tianxuan M Series Handheld Thermal Camera ·User Manual
12
result, especially when the object emissivity is low or the object temperature and the reflection
temperature differ greatly, this effect will increase. So the result needs to be compensated to
eliminate influences of the surface reflection temperature. However, it is usually difficult to determine
the reflected temperature of an object. The ambient temperature can be used to replace the reflected
temperature in actual measurement.
 Distance: distances have effects on the measurement results. In order to get accurate measurement,
distance information of the object is necessary for the thermal camera to compensate the result.
4.7 Palettes
In the observation interface, short press OK to enter the main menu, and select "palette setting" with the
navigation button. Press OK again to enter the sub menu, select different palettes by shifting left and right
on the navigation button, and then press the enter button to save your option.
In the observation interface, click anywhere on the touch screen to enter the main menu. Click "palette
setting" to choose a palette and save your option by clicking the screen area.
4.8 Image Mode
4.8.1 Image Mode Introduction
Four image modes are available.
 Thermal Fusion: an image fused to a certain scale between an infrared image and a visible image
 PIP: infrared image superimposed at the center of the visible image
 Thermal imaging: infrared images
 Digital camera: visible images
Note: For better dual-light image effects, when in PIP or thermal fusion modes, you need to set the actual
distance, that is, the approximate distance from the thermal camera to the object. If the preset registration
parameters cannot meet the requirements, you can also manually perform fusion registration in the
settings.
4.8.2 Setting Steps
In the observation interface, press OK shortly to enter the main menu, and select "image mode" through
the navigation button. Then press OK again to enter the secondary menu, there different image mode can
be selected by shifting left or right on the navigation button. Save your option by pressing enter button.
In the observation interface, click any place on the screen to enter the main menu. Click "image mode"
and select the desired image mode, and then click on the screen area.