User Manual

Tianxuan M Series Handheld Thermal Camera ·User Manual
10
4. Operation Instruction
4.1 Charging
4.1.1 Charge with a Power Adapter
1. Plug the power adapter into the socket.
2. Use a USB cable to connect the adapter and the camera to charge.
Note：It takes about 3h to get the device fully charged.
4.1.2 Charge with a Computer
1. Use a USB cable to connect the thermal camera to the computer to charge.
Note: when charging with a computer, the computer should be turned on, and the charging time is longer
than using an adapter.
4.1.3 Charge with a Charging Base
1. Connect the power adapter and the charging base with a USB cable, and plug the power adapter into
the socket.
2. Take out the battery and place it correctly in the charging base to charge.
Note：When the battery is not placed, the indicator of the charging base flashes; the indicator turns red
when the battery is placed and charging; the indicator becomes green when the battery is fully charged.
4.2 Power On/Off
1. Press the power button continuously to start the device.
2. Press the power button about 3 seconds to turn it off.
4.3 Image Capturing/Video Recording
1. In the observation interface, adjust the focus ring till the image is clear. Short press the trigger button
to take the photo. Long press the trigger button to start recording video, and finish recording by releasing
the trigger button.
2. Tap the save button on the screen or click OK to save the picture. Tap other buttons on the screen or
use the navigation button + OK to make recording annotation, scan the QR code to name the file, or
cancel saving photos.