Operating Manual
- ●◐ Battery charging capacity 25%-50%
- ●●◐ Battery charging capacity 50%-75%
- ●●●◐ Battery charging capacity 75%-99%
- ●●●● Fully charged
After the battery is fully charged, remove the battery pack from the battery holder.
Note: This battery holder can charge two IBP-2 battery packs at the same time.
Battery Pack Installation
Turn up the pick (14) on the battery
pack, align the orange line (D) on the
battery pack with the orange line (C)
above the battery holder, and push the
battery pack (13) into the battery
holder (21);
When the battery pack is fully inserted into the battery holder, rotate the pick (14)
clockwise to lock the battery pack;
Close the pick (14) to complete the battery pack installation;
The Cabin series can only be powered by this battery pack. If other batteries are used, it
may cause irreparable loss, damage the device, and even may cause fire.
Safety Measures
Use this battery holder to charge the battery pack only. Otherwise it will cause irreparable
damage to the battery pack or holder and even may cause fire.
After a long storage time, the battery pack should be partially charged, not fully charged
or discharged;
Do not charge the device immediately after it is moved to a warm environment from a
cold environment. Wait for 30 to 40 minutes for preheating.
If the charger is modified or damaged, do not use it;