Operating Manual
VI. Battery Charging
The Cabin series is supplied with a quickly removable 18650 Li-ion battery pack, which
enables the device to be used for up to 8 hours. The battery should be fully charged before first use.
Method 1: Type C Charging
Align the orange vertical line on the
battery pack with that next to the battery
holder of the Cabin night vision device,
and install the battery pack into the battery
holder. For details see Battery Pack
Installation;
Connect the Type-C interface (18) of the cable to the Type-C interface (4) of the device;
Connect the other interface to the power adapter (19) of the device, or a USB power
socket with a rated voltage of 5V or lower;
Insert the adapter to a 100-240V power socket (20) for charging.
Method 2: Charging with the Battery Holder
Align the position block (A) of the battery pack with the groove (B) of the battery
charging holder, and insert the battery pack (13) into the battery holder (15);
Connect the Type-C interface of the cable (18) to the Type-C interface (16) of the device;
Connect the other end of the data cable to the
power adapter (19), and insert the adapter
into a 100-240V power socket (20) to charge
the battery pack;
After the above steps are finished, the LED
indicator (17) on the battery holder will light
up or blink:
-
◐ Battery charging capacity 1%-25%