Operating Manual

rightward or downward. One press moves a pixel and pressing and holding
for one time moves the red cursor by 10 pixels each time;
 After finishing moving the cursor, press the M button (7) to save the
setting and exit. The icon X ↔ or Y ↕ stops blinking;
 When Center is selected, press the M button (7) to return the red cursor to
the original default position;
 After moving the red cursor to overlap with the day scope cross center,
press and hold the M button (7) to save the change, the screen will display
the words “Successfully saved”, and return to the main menu screen.
Compass
Calibration
Calibrating the digital compass
 Press and hold the M button (7) to open the main menu;
 Press the Up button (6) or Down button (8) to select the "Compass
Calibration" function option;
 Press the M button (7) to go to the Compass Calibration screen. The
calibration icon will be displayed;
 Rotate the device along the three axes indicated by the icon, with each axis
rotating at least 360°;
 The calibration ends after 15s by default and the screen closes
automatically.
Standby
Setting the standby state and duration
 Press and hold the M button (7) to open the main menu;
 Press the Up button (6) or Down button (8) to select "Standby";
 Press the M button (7) to enable/disable the standby function (after
enabling, if there is no operation within 15 minutes, the device will switch
to standby mode automatically);
 The icon in the status bar changes accordingly after this mode is turned on
or off.
Settings
This function is used to set the date, time, language, status auto-hiding, factory
reset, and device information query.