Operating Manual

Compensation
Press the Up button (6) or Down button (8) to select the "Exposure
Compensation" function option;
Press M button (7) to go to the "Exposure Compensation" function option
screen;
Press the Up button (6) or Down button (8) to adjust the exposure
compensation value as required;
After finishing moving the cursor, press the M button (7) to save the
setting and exit. The icon stops blinking.
Reticle
Position
Adjustment
When the position of the cross center of the day scope is inconsistent with the
position of the infrared cross cursor shown on the device (that is, the digital
zoom center position), you can use this function to adjust the position of the
infrared cursor so that the center position of the cross reticle for day scope
becomes the digital zoom center of the screen.
Press and hold the M button (7) to open the main menu;
Press the Up button (6) or Down button (8) to select the "Reticle Position
Adjustment" function option;
Press M button (7) to go to the "Reticle Position Adjustment" function
option screen;
The red cross cursor appears in the middle of the screen and the prompts
shown in the following figure are displayed in the upper left corner:
- X indicates the X-axis in the horizontal direction;
- Y indicates the Y-axis in the vertical direction;
- Center allows the cursor to return to the center of the screen;
Press the Up button (6) or Down button (8) to switch over between
options. Press the M button (7) to confirm the selection;
When selecting the X or Y axis, the icon of the selected option will keep
blinking. Press the Up button (6) or Down button (8) to move the red
cursor. If you press the Up button (6), the red cursor will move leftward or
upward. If you press the Down button (8), the red cursor will move