Installation Instructions

Eye Series
Thermal Monocular
Quick Start Guide
2021.07
IRay Technology Co., Ltd.
Tel 0086-400-998-3088
Web www.infirayoutdoor.com
Email [e-mail]
Add 11th Guiyang Street YEDA, YanTai 264006 P.R. China
After the device is connected to a computer through a USB
cable, you can open the device memory on the computer
and read the stored photos and videos.
19. Data Catching
When the indicator light is flashing
red, it means the battery is less
than 10%. Please charge the
device in time. At the same time,
there will be relevant text prompts
on the screen.
Open the USB cover at the bottom, plug in the USB
charging cable, and connect with the power to charge,
or use a portable power source to charge the device.
During charging, the indicator is yellow. When it turns
green, the charging is completed.
20. Charging
confirm your selection.
If Yes is selected, the following settings will be restored to
the factory state:
Image Mode - white hot mode,
Brightness - level 2,
E-zoom - ×1,
Calibration Mode - S,
and the other functions are off.
Note: Restore factory settings will format memory, so
please save the data in advance.
AttentionModel
1. The rated charging voltage of this product is 5V, please
charge timely when power is low, so as to avoid the service life
loss caused by battery over-discharge.
2. The thermal imager is not recommended to use in
hightemperature environment for a long time, if the temperature
is too high, the imager will enter the high-temperature
protection state, and automatically shut down.
3. The use of temperature is recommended at -10°C to +50°C.
Otherwise, the service life of the product will be affected.
4. Make sure that the USB/MCX port cover of the thermal
imager is tightly plugged firstly when using in water
environment, such as rainy days.
5. Under any circumstances (whether on or off), do not expose
the thermal imager directly into the high-intensity radiation
sources (such as the sun, laser, etc.), to avoid irreversible
damage to the device.
6. The B correction mode will reduce the frequency of
automatic shutter correction after the condition of the device
become stable. If the image gets worse, please cover the lens
cover for manual background correction.
7. When the device is not used for a long time, it should be
charged at least 2 months during storage and stored in a dry
and ventilated environment.
˟ Actual operation time depends on the intensity of Wi-Fi use and
the built-in video recorder.
˟˟ Technical parameters of the device may be improved without
prior notice of the customer.
8. Do not shine the laser pointer on human eyes.
9. Do not be charged in an environment above 40°C.
*O3BZ0VUEPPS
E3w C2w
256×192
12
25
13
13.5°×10.1°
×2
384×288
17
50
19
19.5°×14.7°
×2/×4
E3wC2w
≤40
-$04
675 696
12
420
7
500
16
160×62×62
Detector Resolution, pixels
Pixel Size, μm
NETD, mK
Frame Rate, Hz
Objective Lens, mm
Field of View
Display Resolution, pixels
E-zoom,×
Recorder, G
Max. Battery Life
˟
, h
Weight, g
Dimension, mm
Detection Range , m
(Target size:1.7m×0.5m,
P(n)=99%)
Eye Series