User Guide

Specification
22
23
CleanMate
Description
4.5 meters per second, 9000 rpm vacuum motor
Output: 20Vdc 1000mA
Input: 100 - 240V 50 - 60 Hz
Ni-MH 14.4V, Rechargeable, 3.5 hours of charging time
QQ2 Basic 2.5 Ah battery, QQ2 ECO 1.8 Ah battery
80dB at distance of 20 cm
6000 hours continuously
0.3 liter
12.5 ~ 14.5 cm/sec
Infrared light with more than 3 meters controlling range,
3V button Lithium battery CR2032
5 types: Spiral, Special Bounce, Along Wall, S shape, Polygonal Spiral
36cm(Diameter)x 9cm (H) or 14inch (diameter) x 3.5 inch (H)
3kg
Item
Suction Power Speed
Fast adapter/charger
Battery
Noise
Life time of UV ray
Capacity of dust bin
Moving speed of machine
Remote control
Types of movement
Dimension
Weight
Troubleshooting
This trouble shooting guides cover some CleanMate problems that you might have.
If problem persists, please contact your local warranty provider or www.infinuvo.com for further
assistance.
The repairs that marked * needs to be done by qualified service personal.
CleanMate
Problem Symptoms Possible Cause Things to do
Battery installation problem
Make sure battery has good contact with
charging stripes, and battery lifting band
faces up
Battery malfunction
Charge battery manually for 2 days (see
Page 10) or replace battery
CleanMate is lifted off ground
over 3 seconds while running
Put the CleanMate back on to the ground.
CleanMate is stuck
Remove deris & hairs from brushes and
wheels
LOW BATT indicator on Battery power is low Recharge the CleanMate battery
Fall down steps or stairs Malfunction cliff sensors Repair the CleanMate main unit *
Always turning in circles to
left
Left wheel stuck or
malfunction
Clean or replace left wheel
Always turning in circles to
right
Right wheel stuck or
Malfunction
Clean or replace right wheel
Bumper protection pads not
removed
Remove bumper protection pads
Malfunction front bumper
sensor
Clean or replace front bumper sensor *
Malfunction control board Replace control board *
Too much debris & hairs on
brush
Remove debris & hairs from roller brush.
Replace the roller brush if necessary
Malfunction brush motor Replace brush motor *
Too much debris & hairs on
brush
Remove debris & hairs from side brush.
Replace the side brush if necessary
Malfunction brush motor Replace brush motor *
Remote control battery bad
Replace the button battery in the remote
control .
Remote control malfunction Replace the remote control
Both ERROR & LOW BATT
indicators are on
ERROR indicator on
Always going backwards
Remote control does not
work
Side brush stuck
Main roller brush stuck