User Guide

19
Clean Mate 365
Illustration 3 Illustration 4 Illustration 5
Tab
Illustration 6 Illustration 7
Illustration 8 Illustration 9 Illustration 10
Cleaning the CleanMate
Over time dust and dirt can accumulate in different areas of the unit, DO
NOT use water to clean the unit itself! This is an electrical unit, and if any
of the electric components get wet, the unit will no longer work, and could
cause a short circuit and potentially harm someone. Use Canned Air, the
Hand Brush provided with the unit, or a dry cloth to wipe away
accumulated dust and dirt.
Clean Mate 365
QQ-1
18
Cleaning Dust Bin and Air Filter
Cleaning the Vacuum Entry
After operating the machine for a period of time, dust and dirt will
accumulate on the vacuum entry on the bottom of the CleanMate. Cleaning
this area regularly will help ensure that the unit performs properly.
1.Make sure the power of the CleanMate is turned off.
2.Turn the unit upside-down, and brush any dust that has accumulated
inside the vacuum entry as shown below.
Shake the dust out into a trash can.
Side Brush
Vacuum Entry
Cleaning the Roller Brush
Hair and other stringy items can get caught in the roller brush over time.
1. Make sure the power to the unit is turned off.
2.Turn the CleanMate upside-down and place it on a flat surface with the
back of the unit facing you.
3. Remove the Roller Brush from its compartment by grabbing the left side
of the Roller Brush, and sliding it toward the right until the left side brush
is free.
4.Lift the free end of the Roller Brush out of the compartment, then slide
the Roller Brush to the left, freeing it from the flexible insert.
5 Remove any hair, string or other debris from the roller brush to ensure
proper performance of the unit.
6.With the Roller Brush removed, loosen any dirt that has accumulated in
the Roller Brush compartment with a brush, then dump the dirt into a trash
can.
7.Re-install the roller brush following the steps outlined in Roller Brush
Installation and Removal Section (P.13)
CleanMate
CleanMate