Instruction Manual
to improve environmental performance of batteries and all operators
in the supply chain.
Instructions for Users on Removal, Recycling and Disposal
of Used Batteries
To remove the batteries from your equipment or remote control,
reverse the procedure described in the owner’s manual for inserting
batteries. For products with a built-in battery that lasts for the
lifetime of the product, removal may not be possible for the user.
In this case, recycling or recovery centers handle the dismantling
of the product and the removal of the battery. If, for any reason, it
becomes necessary to replace such a battery, this procedure must be
performed by authorized service centers. In the European Union and
other locations, it is illegal to dispose of any battery with household
trash. All batteries must be disposed of in an environmentally
sound manner. Contact your local waste-management ocials for
information regarding the environmentally sound collection, recycling
and disposal of used batteries.
WARNING: Danger of explosion if battery is incorrectly replaced.
To reduce risk of re or burns, don’t disassemble, crush, puncture,
short external contacts, expose to temperature above 60°C (140°F),
or dispose of in re or water. Replace only with specied batteries.
The symbol indicating ‘separate collection’ for all batteries and
accumulators shall be the crossed-out wheeled bin shown below:
In case of batteries, accumulators and button cells containing more
than 0.0005 % mercury, more than 0.002 % cadmium or more
than 0.004 % lead, shall be marked with the chemical symbol
for the metal concerned: Hg, Cd or Pb respectively. Please Refer
to the below symbol:
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD [The remote
control supplied with] This product contains a coin/button cell
battery. If the coin/button cell battery is swallowed, it can cause
severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product and
keep it away from children. If you think batteries might have been
swallowed or placed inside any part of the body, seek immediate
medical attention.
For All Products Except Those with Wireless
Operation:
HARMAN International hereby declares that this equipment
is in compliance with the EMC 2014/30/EU Directive, LVD
2014/35/EU Directive. The declaration of conformity may be
consulted in the support section of our Web site, accessible from
www.infinitylab.com
For All Products with Wireless Operation:
HARMAN International hereby declares that this equipment is in
compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. The declaration of conformity
may be consulted in the support section of our Web site, accessible
from www.infinitylab.com
HARMAN International Industries, Incorporated. All rights reserved.
Infinitylab is a trademark of HARMAN International Industries,
Incorporated, registered in the United States and/or other
countries. Features, specications and appearance are subject to
change without notice.
www.infinitylab.com
IOT_Infinity_LAB safety sheet_Global_DV1_V3 (100x50mm).indd 4IOT_Infinity_LAB safety sheet_Global_DV1_V3 (100x50mm).indd 4 10/29/2020 6:20:12 PM10/29/2020 6:20:12 PM