Instruction Manual
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
For all products:
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not block any ventilation openings. Install this apparatus in
accordance with the manufacturer’s instructions.
6. Do not install this apparatus near any heat sources such as
radiators, heat registers, stoves or other apparatus (including
ampliers) that produce heat.
7. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or
the third prong is provided for your safety. If the provided
plug does not t into your outlet, consult an electrician for
replacement of the obsolete outlet.
8. Use only attachments/accessories specied by the manufacturer.
9. Unplug this apparatus during lightning storms or when
unused for long periods of time.
10. To disconnect this apparatus from the AC mains completely,
disconnect the plug from the AC receptacle.
11. The mains plug of the shall remain readily operable.
12. Do not expose batteries to excessive heat such as sunshine,
re or the like.
13. This apparatus is intended to be used only with the plug and/
or charging cable provided by the manufacturer.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THE LIGHTNING FLASH WITH AN ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE
OF UNINSULATED "DANGEROUS VOLTAGE"WITHIN
THE PRODUCT'S ENCLOSURE THAT MAY BE OF
SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK
OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN
EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
CAUTION FCC AND IC STATEMENT FOR USERS
(USA AND CANADA ONLY)
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation. CAN ICES-3(B)/NMB-3(B)
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
HARMAN International hereby declares that this equipment is in
compliance with the FCC Part 15 Subpart B.
The declaration of conformity may be consulted in the support
section of our Web site, accessible from www.infinitylab.com
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
IOT_Infinity_LAB safety sheet_Global_DV1_V3 (100x50mm).indd 2IOT_Infinity_LAB safety sheet_Global_DV1_V3 (100x50mm).indd 2 10/29/2020 6:20:12 PM10/29/2020 6:20:12 PM