TSS-SAT500 OM 11/14/05 4:14 PM Page 1 TOTAL SPEAKER SOLUTIONS TSS-SAT500 Owner’s Guide
TSS-SAT500 OM 11/14/05 4:14 PM Page 2 TSS-SAT500 OWNER’S GUIDE Table of Contents 2 3 Introduction 3 Included 3 Planning Your System 3 Placement 4 Wall-Mounting 5 Connections 5 Maintenance and Service 7 Specifications TSS-SAT500
TSS-SAT500 OM 11/14/05 4:14 PM Page 3 INTRODUCTION PLACEMENT Infinity Total Solutions ™ Infinity Total Solutions continues Infinity’s longstanding commitment to accurate sound reproduction. Our high-quality drivers, precision dividing networks and rigid, well-braced enclosures combine to deliver uncompromised performance in any multichannel home theater system. In addition, the TSS-SAT500 is magnetically shielded for safe placement adjacent to a television.
TSS-SAT500 OM 11/14/05 4:14 PM Page 4 WALL-MOUNTING The TSS-SAT500 satellite is designed to be mounted on the wall. There is a wall bracket included.The speaker bracket will require four 1-1/2" #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2" #10 screw. Step 5. Screw the ball and shaft assembly (B) to 1/4"-20 insert on rear of speaker. Back out 1/2 of a turn and tighten nut against the speaker.
TSS-SAT500 OM 11/14/05 4:14 PM Page 5 CONNECTIONS MAINTENANCE AND SERVICE After placing the speakers, you are ready to connect your system. First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-gauge speaker wire with polarity coding is included. For longer distances, #16-gauge or heavier wire is recommended.The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., +).
TSS-SAT500 OM 11/14/05 NOTES 6 TSS-SAT500 4:14 PM Page 6
TSS-SAT500 OM 11/14/05 4:14 PM Page 7 SPECIFICATIONS TSS-SAT500 Frequency Range: 150Hz – 25,000Hz (±3dB) Recommended Amplifier Power Range: 10 – 100 Watts Sensitivity: 86dB (2.83V @ 1 meter) Nominal Impedance: 8Ω Crossover Frequency: 7,000Hz Midrange Driver(s): 2-1/2" (64mm) Magnetically shielded High-Frequency Driver: 3/4" (19mm) Magnetically shielded Dimensions (H x W x D): 7-11/16" x 3-1/2" x 2-3/4" (195mm x 89mm x 70mm) Weight: 1.2 lb (0.
TSS-SAT500 OM 11/14/05 4:14 PM Page b © 2005 Harman International Industries, Incorporated. All rights reserved. Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA www.infinitysystems.com Infinity and Harman International are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Total Solutions is a trademark of Harman International Industries, Incorporated. Dolby and Pro Logic are registered trademarks of Dolby Laboratories.
