Owner's Manual

KAPPA
4. Remote (K600, K1000, K5):
Connect an 18awg wire from the “Remote Out” lead of the source unit to the REM input. This lead detects signal and instructs the amplifier to
turn on. (See 12. REM below for remote connection info for the K2 and K4 models.)
Kappa REM input power block
5. Front and rear inputs and outputs (RCA):
• If your source unit offers preamp outputs, connect to the FRONT, REAR, and/or SUB inputs using RCA patch cables.
• To connect a second amp directly to the amplifier, run a patch cable from the PRE OUT outputs to the second amp’s preamp inputs. (Available
on K2 and K4 amplifiers only.)
6. Input level:
Select LO if providing signal to the amp using line-level connections. Select HI1 or HI2 if using speaker-level connections.
7. Crossover filter selectors (K2, K4, K5):
Slider switches for selecting high-pass (HP), low-pass (LP), or FULL. K600 and K1000 filters are low pass only. (See Setting the Crossover in
Chapter 4.)
8. Gain:
Use input level controls to match the amp’s input sensitivity to the output level of your source unit. (See Setting the input levels in Chapter 4 for
a recommended adjustment procedure.)
9. Crossover Frequency Controls:
Use crossover-filter frequency controls for adjusting crossover point settings for full-range speakers and subwoofers. (See Setting the
Crossover in Chapter 4.)
10. ADAS Assign (K2, K4, K5):
When you connect your ADAS system to your Kappa amp (cable sold separately), the amp will broadcast your vehicle’s driver assistance
messages, such as lane-departure warnings. By turning the ADAS Assign dial you can select the speaker the messages will be broadcast over.
You can choose to hear messages over your front left or FL (driver’s side), front right or FR (passenger side), rear left, or rear right speaker.
Your music will mute when a warning or message is broadcast, then resume when they’re finished.
+12V
REM
GND
6