Owner's Manual
NOTES:
• Use appropriately sized speaker wire;
14-
or
16-gauge
is
recommended.
• Make sure
your
amplifier's RMS
pcwer
rating Is suitable for the
tweeters and woofers (see specifications).
• You will need
to
use a total
of
four channels
of
amplification
from
two
2-channel amplifiers
or
one 4-channel amplifier.
IMPORTANT: Because
of
the lower impedance
of
the drivers,
do
not
wire
In
parallel
or
bridge amplifier channels
to
prevent
overheating the amplifier.
Connecting the amplifier
to
the crossover:
non-bi-amping
• Slide
'Bl-AMP'
switch
to
'off"
Bl-AMP
(
ON
OFF
• Connect a single amplifier
output
channel with speaker wire
to
the crossover
'IN"
terminal marked WOOFER/2-WAY
on
each
of
the crossovers.
WOOFER/2-WAY
00
+
NOTES:
• Use appropriately sized speaker wire;
14-
or
16-gauge is
recommended.
• Make sure your amplifier's RMS power rating
is
suitable for the
woofers (see specifications).
• You will only need
to
use
two
channels
of
amplification.
IMPORTANT: Because
of
the lower impedance
of
the drivers,
do
not
wire in para
ll
el
or
bridge amplifier channels
to
prevent
overheating
of
the amplifier.
Recommended wiring diagrams
Bi-amping
+
O
LEFT
TW££TER
LEFT
WOOR'R
+
0
~£T£R
+
Non-bi-amping
+
+
O
~mR
OIClHT
1W£ETER
l
I.
c:::-=
_==-:J]
l£"',\f()()ffA
Crossover sound settings
You can set the crossovers according
to
your sound preferences.
• You can raise
or
lower
the woofer output
by
sliding the
"TWEETER
DB
LVL" switch
to
-1.5dB. OdB,
or+
1.5dB.
TWEETER
dB
LVL
[
•J
-1.5 0
+1
.5
• You can use the "TWEETER
HZ
CUTT OFF" switch
to
choose
to
have the tweeter play frequencies from either 2.5kHz and
above
or
3.5kHz and above.
TWEETER
Hz
CUTT
OFF
[
•J
3.5k 2.5k
Mounting the crossovers
Find a location in your vehicle
to
secure the crossovers that will
not
interfere with vehicle operation. If mounting
In
a
door
panel, it
is recommended that you use
self
adhesive strips
of
hook-and-
loop fasteners.
-