Specifications

7
INSTALLATION
CONNECTING THE SUB LEVEL CONTROL
TO BASSLINK
The Sub Level Control may be mounted under
the dash or may be dismantled and mounted in
the dash for a factory appearance.
UNDER-DASH MOUNTING
Select a mounting location that allows easy
access to the control while driving. Using
the Sub Level Control as a template, mark and
drill holes in the mounting surface. Attach the
Sub Level Control using the mounting screws
provided (Figure 13).
IN-DASH MOUNTING
Disassemble the Sub Level Control by removing
the two Phillips-head screws on the front panel,
rear panel and on top. Remove the Sub Level
Control’s bottom and side panels. Slide the Sub
Level Control’s PC board forward to release the
RJ11 connector from the back panel and remove
the board along with the potentiometer, knob
and connector as a single assembly.
Figure 13. Under-dash mounting of the Sub Level
Control.
Choose a mounting location that allows easy
access to the control, and provides 1-3/4"
clearance behind the mounting surface. Drill
a 9/32" hole in the mounting surface. Feed the
Sub Level Control’s potentiometer (with the
knob removed) through the hole and use the nut
provided to hold the control in place (Figure 14).
Figure 14. In-dash mounting of the Sub Level
Control.
Route the cable behind the dash or other interior
panels and under the carpet. Do not route the
cable outside the vehicle. Connect the RJ11 cable
between the RJ11 receptacle on the BassLink and
the receptacle on the Sub Level Control (Figure 15).
Figure 15. Sub Level Control electrical connection.