Specification Sheet

S-TIFAS 99 Series
SITE SIZABLE STAINLESS STEEL
▪ S-TIFAS 9940 - 40” Complete Kit
▪ S-TIFAS 9948 - 48” Complete Kit
▪ S-TIFAS 9960 - 60” Complete Kit
▪ S-TIFAS 9980 - 80” Complete Kit
▪ S-TIFAS 9996 - 96” Complete Kit
Features
▪ Modify length and outlet location on site
▪ Indoor or outdoor use
▪ Stainless steel channel
▪ 12 gauge. 304L stainless steel perforated grate
▪ Works with 3” clamp down oor with 4” throat/strainer size
(included)
▪ NOT INTENDED for installation across a barrier-free threshold
▪ Compatible with: PVC Liner, Rubber Liner (Chloraloy ®), Hot
Mop, Lead Pan, Copper Pan, or Fiberglass
▪ Flow rate - 21 gpm per outlet
▫ Flow rate measured at outlet only. Measurement does not account
for water in channel or sheeting on shower oor.
▫ Additional outlets can be added and combined into a larger waste
line to increase ow rates
Installation
Care & Maintenance
S-TIFAS 99 stainless steel linear drain top grates are made of 304L stainless steel. This material is non-porous, hygienic, rust-free and extremely
durable. Bar Keepers Friend® and Soft Scrub® are commonly available products that can be used to protect and clean your Satin Stainless drain
cover. For stains that have been left for an excessive amount of time, stronger cleaning agents such as Compound 302® may be needed. For
Polished Stainless and Oil Rubbed Bronze we recommend a mild soap and a soft cloth for cleaning. DO NOT use any abrasive cleaners, scrub
pads or allow household cleaning agents, such as bleach, to sit on the drain cover for a long period of time. Stainless steel does not rust. External
factors, such as contamination from other highly ferrous metals, built up road salt, sea salt, or chlorine may have caused ”surface” rust which can
be removed using Barkeepers Friend®, Soft Scrub® with Bleach, or Compound 302® . Always follow the directions on the bottle. Follow proper
maintenance procedures to prevent excessive surface rust. In areas of frequent exposure to salt, chlorine, and other chemical compounds,
maintenance of the stainless grates should be performed at least 2-3 times per year.
Page 1 of 3
Dimensions are subject to manufacturers tolerance and change without notice. We can assume no responsibility for use of superceded or void data.
Innity Drain
18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.Innity Drain.com
NOTE: Installer must verify all rough-in
dimensions prior to installation and consult
local and national codes. Conformity and com-
pliance to local and national codes are the
responsibility of the installer.
FM019-04-19