Specification Sheet

S-TIF 65 SeriesS-TIF 65 Series
SITE SIZABLE PVC
SUBMITTAL
 S-TIF 6540 - 40” Complete KitS-TIF 6540 - 40” Complete Kit
 S-TIF 6548 - 48” Complete KitS-TIF 6548 - 48” Complete Kit
 S-TIF 6560 - 60” Complete KitS-TIF 6560 - 60” Complete Kit
 S-TIF 6580 - 80” Complete KitS-TIF 6580 - 80” Complete Kit
 S-TIF 6596 - 96” Complete KitS-TIF 6596 - 96” Complete Kit
Features
 Modify length and outlet location on site
 Indoor or outdoor use
 PVC Channel
 12 gauge, 304L stainless steel Tile Insert Frame
 Works with 2” clamp down oor with 2” throat/strainer size
(not included)
 NOT INTENDED for installation across a barrier-free threshold
 Compatible with: PVC Liner, Rubber Liner (Chloraloy ®), Hot
Mop, Lead Pan, Copper Pan, or Fiberglass
 Flow rate - 9 gpm per outlet
▫ Flow rate measured at outlet only. Measurement does not account
for water in channel or sheeting on shower oor.
▫ Additional outlets can be added and combined into a larger waste
line to increase ow rates
Installation
Care & Maintenance
S-TIF 65 stainless steel linear drain top grates are made of 304L stainless steel. This material is non-porous, hygienic, rust-free and extremely
durable. Bar Keepers Friend® and Soft Scrub® are commonly available products that can be used to protect and clean your Satin Stainless drain
cover. For stains that have been left for an excessive amount of time, stronger cleaning agents such as Steel Brite Cleaner may be needed. For all
nishes we recommend using mild soap and a soft cloth for cleaning. DO NOT use any abrasive cleaners, scrub pads or allow household cleaning
agents, such as bleach, to sit on the drain cover for a long period of time. Stainless steel does not rust. External factors, such as contamination
from other highly ferrous metals, built up road salt, sea salt, or chlorine may have caused ”surface” rust which can be removed using Barkeepers
Friend®, Soft Scrub®, or Steel Brite Cleaner. Always follow the directions on the bottle. Follow proper maintenance procedures to prevent ex-
cessive surface rust. In areas of frequent exposure to salt, chlorine, and other chemical compounds, maintenance of the stainless grates should
be performed at least 2-3 times per year.
Page 1 of 3FM017-01-22
Dimensions are subject to manufacturers tolerance and change without notice. We can assume no responsibility for use of superceded or void data.
Innity Drain
145 Dixon Avenue
Amityville, NY 11701
Phone: [phone]
Fax: [phone]
www.Innitydrain.com
NOTE: Installer must verify all rough-in
dimensions prior to installation and consult
local and national codes. Conformity and com-
pliance to local and national codes are the
responsibility of the installer.