Specification Sheet

Center Drains
Standard Installation
Features
▪ 3/16” Thick Stainless Steel Strainer - Compression Fit
▪ 2” Residential Throat or 4” High Flow Throat (for 5” strainers)
▪ Indoor or Outdoor Use
▪ Drain body (Cast Iron, PVC, or ABS) with 2” or 4” throat
▪ Includes hair strainer and lift-out key
▪ Available in 6 patterns and four nishes
▪ Requires traditional 4-way oor pitch
▪ Compatible with: PVC Liner, Rubber Liner (Chloraloy ®), Hot
Mop, Lead Pan, Copper Pan, or Fiberglass
▪ Flow rate - measured at outlet only. Measurement does not account for
water in throat or sheeting on shower oor.
9 gpm - Residential 2” Throat
21 gpm - High Flow 4” Throat
Installation
Care & Maintenance
Center drain stainless steel linear drain top grates are made of 316L stainless steel. This material is non-porous, hygienic, rust-free and extremely
durable. Bar Keepers Friend® and Soft Scrub® are commonly available products that can be used to protect and clean your Satin Stainless drain
cover. For stains that have been left for an excessive amount of time, stronger cleaning agents such as Compound 302® may be needed. For
Polished Stainless and other nishes we recommend a mild soap and a soft cloth for cleaning. DO NOT use any abrasive cleaners, scrub pads
or allow household cleaning agents, such as bleach, to sit on the drain cover for a long period of time. Stainless steel does not rust. External
factors, such as contamination from other highly ferrous metals, built up road salt, sea salt, or chlorine may have caused ”surface” rust which can
be removed using Barkeepers Friend®, Soft Scrub® with Bleach, or Compound 302® . Always follow the directions on the bottle. Follow proper
maintenance procedures to prevent excessive surface rust. In areas of frequent exposure to salt, chlorine, and other chemical compounds,
maintenance of the stainless grates should be performed at least 2-3 times per year.
REV. 05.01.17
Dimensions are subject to manufacturers tolerance and change without notice. We can assume no responsibility for use of superceded or void data.
Innity Drain
145 Dixon Avnue
Amityville, NY 11701
Phone: [phone]
Fax: [phone]
www.Innity Drain.com
NOTE: Installer must verify all rough-in
dimensions prior to installation and consult
local and national codes. Conformity and com-
pliance to local and national codes are the
responsibility of the installer.