Installation Sheet

6
Suboor
Stainless Steel
Channel Assembly
Final Mortar Bed
Clamp Down
Floor Drain
Pre-Pitched
Mortar Bed
Waterproong
Membrane
Finishing Material
Backer Board
Thinset
Finished Grate
8. Using desired oor material, mark the
thickness of the material along the channel so
that it will nish 1/16” above the channel. Lay
nal mortar bed across the wet area. Pitch
this bed in one plane toward the linear drain.
Ensure space for thinset and nishing mate-
rial to nish 1/16” above the channel. After
dry, apply a bead of silicone caulk around the
channel. Lay thinset and nishing material,
and have material nish to the edge of the
combined stainless steel channel. DO NOT
allow nishing material to nish on top of the
stainless steel channel edge.
9. FXTIF 65/TD 50 INSTALL: Spread a layer
of mortar into the Tile Insert Frame (TA65),
allowing for thinset and nishing material to
nish 1/16” above the metal frame. Allow to
dry, spread thinset and lay material.
8. Utilizando el material de piso deseado, marque
el espesor del material a lo largo del canal para
que termine 1/16” arriba del canal. Sentar la últi-
ma capa de mortero a través de la zona mojada.
Lanzar esta capa en un plano hacia el drenaje
lineal. Asegura que el espacio para el thinset
y el material terminen 1/16” arriba del canal.
Una vez este seco, aplique un cordón de silicona
alrededor del canal. Colocar el thinset y material
terminado, y tener el material terminado al borde
del canal de acero inoxidable. NO DEJE o PERMI-
TA que el material terminado termine en la parte
superior del canal de acero inoxidable.
9. FXTIF 65/TD 50 INSTALACION: Extender
una capa de mortero en la inserción en la
parte (TA65), permitiendo el thinset y el mate-
rial terminado a 1/16” arriba de la estructura
de metal. Permitir que se seque, difundir el
thinset y tender el material.
Caulking
Mortar Bed
Mortar Bed
Sub-oor
Waterproong
Membrane
Finishing Material
Assure that grate is lower
than installed tile
Mortar
Bed
Mortar Bed
Sub-oor
Waterproong
Membrane
Before nishing
material
Antes que el material
esté terminado
After nishing
material
Después que el material
esté terminado