User's Manual

Infinition Inc. Rev. 02
6
Trigger Source
Select the source of the event triggering the measurement. The user can
select from the following:
 Trigger : Use the internal microphones built in the
product’s enclosure or an external Trigger device.
 Doppler : Use the Signal returned from the projectile to
Trigger the unit: (Use of this mode should be considered with
large projectiles travelling at really slow speed only). Do not
use this mode for Firearms, it will affect the precision of the
measurements.
Trigger Level
Select the sensitivity of the system to detect the trigger event. The user can
select level 1 (more sensitive) through 5 (Less sensitive). This setting
affects:
 The Internal acoustic trigger level;
 The External trigger level;
 The Doppler trigger level;
TX Channel
Select the frequency of transmission of the Radar. In order to use multiple
radars close to each other, use a different frequency for each radar. Failure
to do so may result in bad operation of the radar. For contiguous Labradar,
try to use at least a 2 channels separation.
TX Power (US, Canada, Australia models only)
Select the LabRadar transmitting power. (High or Low). While High power
offers a longer range measurement range, the low power mode can be useful
and perform better on shorter shooting ranges and on ranges where object
create signal reflexions.
System Date
Set the system Date.
System Time
Set the system time.
Format SD Card
Format the memory card (SD card) inserted in the unit.
WARNING: Performing this action will delete the data on this card and it
will be lost forever. This action can take a few minutes to complete, do not
remove the SD card or turn off the LabRadar while operation is in progress.
Format Int. Mem.
Erase the results from the internal memory of the device.
About
View the radar’s information (Serial Number, Firmware version, etc.)